Dornoch UL-EV100, Technical Manual

Page: 14 / 33

Ultra Evac Technical Manual 9 2/8/2013
GD-99013 Rev. D
Instructions for Use
Processing Reservoirs
Step 1 – Insert the coupler into the receiver and gently press the handle
down. (Figure 5)
Step 2 – Verify that all reservoirs have green lids/manifolds and that all
of the ports are capped.
CAUTION: Caps must be on all ports prior to washing to prevent
wash fluid from leaking out onto the top of the cart during processing.
Step 3 – Follow the on-screen instructions to start the processing cycle.
Step 4 – When processing is complete (Figure 6), verify the reservoirs
are clean. If reservoirs are not clean, proceed to the Reprocessing
Reservoirs instructions below.
Step 5 – Press the “REMOVE COUPLER” button and remove the
coupler by first pressing down gently on the handle and then lifting up
while pulling the coupler out of the receiver. Place the receiver in the
storage unit.
CAUTION: ALWAYS press down gently on the handle prior to
removing the coupler. Failure to do so could cause damage to the
equipment.
Reprocessing Reservoirs (Optional)
Step 1 - Access the reprocessing options by pressing the “OPTIONS”
button in the upper right corner. (Figure 6)
Step 2 - Select the desired reservoir(s) and the cleaning cycle and then
press the “START PROCESS” button to perform the selected cycle.
(Figure 7) See “Reprocessing Cycle Descriptions”.
Prepare Cart for Next Case
Step 1 – Remove the used lids/manifolds from each reservoir and
discard according to hospital policy. Processed lids/manifolds can be
identified with a blue filter.
Step 2 – Wipe down the cart with a hospital approved bleach wipe.
(Sani-Cloth Bleach Germicidal Wipe (DMS# UL-BW100), Clorox:
Germicidal Wipes or equivalent)
Step 3 – Move the cart to a clean area and replace the lids/manifolds.
Figure 5 – Coupler Insertion
Figure 6 – Cycle Complete Screen
Figure 7 – Cleaning Cycles Screen