Dorner AquaPruf 7400 Ultimate CE Series, Installation, Maintenance, And Parts Manual

Page: 20 / 46

Dorner Mfg. Corp. 20 851-638 Rev. E
7400 Series CE End Drive Conveyors
Preventive Maintenance and Adjustment
3. Use a punch and hammer to push the belt rod out by
striking the rod end opposite the retaining head
(Figure 55) .
Figure 55
4. Remove the belt rods on both sides of the section of belt
being replaced.
5. Replace the old section with a new section of belt.
Replacing the Entire Belt
1. Remove the belt returns by pushing up on the return
shaft
(Figure 56, item 1) and sliding it through the
large hole (Figure 56, item 2) in the frame.
Figure 56
2. Lower the opposite end of the return shaft
(Figure 56, item 1) and slide it out of the frame.
3. Follow steps 1 – 3 in "Standard Belts: Replacing a
Section of Belt" on page 19.
4. Remove the belt.
5. Replace the damaged or worn belt. Refer to “Belt
Installation” on page 15 and “Belt Return Installation”
on page 16.
Specialty Intralox 1100 Series Belts
Replacing a Section of Belt
1. Place the edge of a flat head screwdriver between the
the two belt links and turn clockwise
(Figure 57) .
Figure 57
2. Use a second belt rod of the same size to push on the
opposite end of the belt rod.
(Figure 58) .
Figure 58
3. Remove the belt rods on both sides of the section of belt
being replaced.
4. Replace the old section with a new section of belt.
CAUTION
CAUTION
DO NOT reuse belt rods that are damaged or
show signs of wear.
1
2
CAUTION
CAUTION
DO NOT reuse belt rods that are damaged or
show signs of wear.