Dorner Mfg. Corp.
8
851-620 Rev. A
7400 Ultimate Series End Drive Conveyors
Installation
Figure 9
1.
Slide the tip up shaft
(Figure 10, item 1)
through the
designated slots in the frame.
Figure 10
2.
Attach the key stops
(Figure 11, item
1)
to the tip up
shaft
(Figure 11, item 2)
. The rounded end of the key
stop should be facing the tail.
Figure 11
3.
Slide the bearing shafts
(Figure 12, item 1)
into the
holes in the tip up shaft
(Figure 12, item 2)
.
Figure 12
Nose Bar Tip Up Tail
Typical Nose Bar Tip Up Tail Components
(Figure 13)
.
Figure 13
1.
Slide the tip up shaft
(Figure 14, item 1)
through the
designated slots in the frame.
2
1
4
3
1
1
2
NOTE
Do not insert the pull pins on the tension end
of the conveyor until the belt has been
installed.
1
Tip up tail assembly
2
Pull pin (x2)
3
Tip up shaft
4
Key stops (x2)
1
2
3
2
4
1
