INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR
741-644
Disclaimer:
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualifi ed auto technician
before attempting to perform any work you are not qualifi ed to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National Highway Traffi
c Safety
Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
ATTENTION:
Refer to the appropriate shop manual for your vehicle to obtain specifi c service procedures for this part. If you do not have
a service manual or lack the skill to install this part, it is recommended that you seek the services of a qualifi ed technician. Pay special
attention to all cautions and warnings included in the shop manual. Read and follow all instructions carefully.
1
©2011 Dorman Products, Inc.
No reproductions in whole or in part without prior written approval.
REMOVAL/INSTALL OF WINDOW REGULATOR (741-644)
Cadillac Escalade, Chevrolet Suburban, Chevrolet Tahoe, GMC Yukon,
Chevrolet Silverado, GMC Sierra 2000–05
General Tech Tips:
•
Use painter’s tape rather than duct tape to secure window. It will not damage paint or leave sticky residue.
•
A plastic pry tool is useful. It will not easily damage delicate trim like a screwdriver or metal pry bar.
•
The replacement regulator should have a liberal amount of grease on slide area. If there is not much grease
present, white lithium grease works well to lubricate the slide area.
•
Aftermarket window tinting can cause the window to travel slower and put additional strain on the window
regulator assembly.
•
Window run channels should be cleaned and lubricated before installation of a new window regulator
assembly. Silicone spray works well.
PLEASE WEAR SAFETY
GLASSES!
Tools required for removal and
installation of window regulator and
motor assembly:
• Phillips screwdriver
• Pry bar with fl at end
• 7mm socket
• 10mm socket
• Socket wrench
• Wooden wedge or wide tape
• Cable cutter (if motor is immovable)
• Silicone spray lubricant
