3 HARDWARE INSTALLATION
WQXM-PG Wi-Q™ Gateway Setup and User Guide | 47
NOTE:
The keypad codes 5678 and the sign-on key should be
presented in rapid success. It is important to not let the controller
time out before entering the 6-digit sign-on code. There should be
no more than a 2 second delay between the 5 6 7 8 (#) keypad
entry and the 6-digit code keypad entry.
Magnetic Card Method
1. Test the reader. Swipe the temporary operator card
through the reader bezel of the WDC or wall mounted
magnetic reader wired to a WAC.
• The WDC controller will display a brief green LED and
unlock.
• The Omnilock controller will display a brief green LED
and unlock.
• The WAC will display a green LED on the controller
board and unlock.
2. Present the temporary operator badge to the reader, look
for the green LED and the reader to unlock.
3. Immediately present the sign-on card to the reader.
Proximity Card Method
1. Test the reader. Present the temporary operator card to
the face of the reader bezel on the WDC, Omnilock or wall
mounted proximity reader wired to a WAC.
• The WDC controller will display a brief green LED and
unlock.
• The Omnilock controller will display a brief green LED
and unlock.
• The WAC will display a green LED on the controller
board and unlock.
2. Present the temporary operator badge to the reader, look
for the green LED and the reader to unlock.
Once this is done, return to the site and sign on the controllers.
For more information see the “Sign On and Configure Controllers
(Task 7)” section on page
.
3.2.8 Sign On Wi-Q Controllers (Task 7)
To successfully sign on Wi-Q Controllers, the temporary operator
card as well as the sign-on cards created in the ACS or the WQXM-
PG are both needed. If the Wi-Q Reader has a keypad, the keypad
code can be used to sign the readers onto the WQXM-PG or the
ACS.
NOTE:
Card offsets other than “0” are not supported for the
WQXM-PG in Mercury Mode. If a card offset other than “0” is used
the end result is that the ACS wil not be able to report which ACR
a transaction came from.
Keypad Method
1. Test the Reader – Enter 1 2 3 4 # on a WDC or 1 2 3 4
on the WAC or Omnilock. The reader should display the
green LED and Unlock.
2. Prepare the Reader to Receive the Sign-on Code –
Enter 5 6 7 8# on the WDC or 1 2 3 4 on the WAC or
Omnilock.
3. Enter the Segment’s Unique Sign-on Key – Enter the
6-digit sign-on key in the ACS or on the segment tab of
the WQXM-PG followed by the # key if the reader is a
WDC. If the reader is a WAC or Omnilock, the # key is not
needed.
□
Example – Key sequence for the WDC: 1 2 3 4 # 5 6
7 5 6 7#
□
Example – Key sequence for the WAC or the Om-
nilock: 5 6 7 8 5 6 7 5 6 7
Summary of Contents for BEST Wi-Q WQXM-PG
Page 2: ...WIRE LESS I NTELLIGENCE TH A T S T ANDS ALONE ...
Page 12: ...1 SYSTEM OVERVIEW ...
Page 14: ...2 SETUP CHECKLIST ...
Page 16: ...3 HARDWARE INSTALLATION ...
