6.2 Downloading data from the system software
This section describes how actuator data and key plans are downloaded from the system
software into the programmer.
After installation of the drivers, the programmer can be used with the desired system
software. The installation and operation of the system software are described in the
corresponding operating manual.
Execute the following steps:
1.
Switch on the PC.
2.
Start the system software.
3.
Connect the programmer to the PC using the USB cable.
4.
Transfer the key plans and the associated actuator data from the system software to the
programmer. The system software procedure is described in the system software manual.
5.
Search for the actuators using the programmer.
6.
For how to transfer the data to the actuators see Chapter
6.3 Set clock
Time on programmer
To use the automatic clock setting on the programmer, execute the following steps:
1.
Switch on the PC.
2.
Start the system software.
3.
Connect the programmer to the PC.
ð
The date and time of the connected programmer are automatically adjusted after the
system software has been started.
Time on actuators
For how to adjust the time on the actuators, see Chapter
.
System connection
User Manual
41
- 06/2021
dormakaba Programmer 1460
