Distributed by:
Dorf Clark Industries Limited
ABN 23 004 394 923
IS898C(04/09)
(SIDE 2 OF 2)
Adjusting the HOT LIMIT RING (ANTI−SCALD STOP RING)
The cartridge fitted in this mixer has been factory pre−set to deliver
the maximum available hot water temperature. To use the ANTI−SCALD
feature adjust the cartridge as follows:−
Carefully remove plug (2). Using 2.5mm allen key (3) loosen screw (4)
and remove handle (1). Unscrew cap (5) taking care not to damage the
decorative finish. (See details on side 1 of this sheet.)
To remove the Hot Limit Ring (7) from the cartridge (9), use a small thin
flat bladed screwdriver and carefully lever in an upwards direction.
Rotate the Ring (7) in a clockwise direction then refit the Ring (7) onto
the cartridge (9).
Note:− Start by rotating the Ring (7) in small increments, then check the
hot water temperature with the mixer handle in the fully open maximum
hot water position. The Ring (7) can be removed & repositioned until the
desired maximum hot water temperature is achieved.
Ensure the Ring (7) is pushed fully down onto the cartridge (9), then replace
cap (5), tightening by hand. Fit handle (1), taking care that it is pushed
fully down, tighten screw (4) and replace plug (2).
PLUMBERS ADJUSTMENT INSTRUCTIONS
JOVIAN − SINK MIXER
WATER EFFICIENT TAPWARE
(NOMINAL FLOW RATE = 7 L/min)
Adjusting the WATER VOLUME LIMIT SCREW
The cartridge fitted in this mixer has been factory pre−set to deliver
the maximum flow of water when the mixer handle is in the fully open
position.
Important Note:− This Sink Mixer is already fitted with a 7.0 L/min
flow regulated aerator insert. Lower flow rates may not be suitable
for connection to some Instantaneous Gas Water Heaters, some Tempering
Valves, some Solar Water Heaters & some Thermostatic Mixing Valves.
Check with the manufacturers of these products.
However, the flow of water may be reduced further by adjusting the cartridge
as follows:−
Carefully remove plug (2). Using 2.5mm allen key (3) loosen screw (4)
and remove handle (1). Unscrew cap (5) taking care not to damage the
decorative finish. (See details on side 1 of this sheet.)
Using a small thin flat bladed screwdriver, adjust screw (8) in an anti−clockwise
direction.
Note:− Start by rotating the Screw (8) in small amounts then check the
flow of water with the mixer handle in the fully open position. Readjust
the screw until the desired water flow is achieved.
Replace cap (5), tightening by hand. Fit handle (1), taking care that it is
pushed fully down, tighten screw (4) and replace plug (2).
7
9
Fig. 2
8
9
Fig. 3