15
FOR CARS FITTED WITH A CHILD RESTRAINT
UPPER ANCHORAGE POINT
Locate the upper anchorage point behind the rear
seating position (consult the car owner’s handbook
for the location of the upper anchorage point).
Remove the thread plug from the parcel shelf/floor/
roof and install the attachment bolt as shown in
Figure 1.
CAUTION: DO NOT OVERTIGHTEN THE
ATTACHMENT BOLT. OVERTIGHTENING MAY
FRACTURE OR BREAK BOLT. MAXIMUM TORQUE
IS 20 Nm.
FOR CARS NOT FITTED WITH A CHILD
RESTRAINT UPPER ANCHORAGE POINT
For sedans only
Drill a 9mm diameter hole in the parcel shelf on
the centre-line of the seating position as shown in
Figure 2. Install the anchor bolt as shown in Figure
3. It is recommended that this installation be carried
out by a child restraint fitting station or licenced
motor mechanic.
For vehicles other than sedans
In Australia, consult your nearest child restraint
fitting station or traffic authority for vehicle
inspection to find the best, correct position for the
placement of the upper anchorage point, and for the
correct attachment bolt length and use of spacers.
In New Zealand, consult the agent for the vehicle.
Preparing vehicle for your seat
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Lock washer
Nut
Reinforcing
washer
Centre line of
seating position
200mm
min.
FOR SEDANS ONLY:
1
2
3
Front of vehicle
