ANCHORAGE FITTING INSTALLATION
(cont)
For cars is fitted with a child restraint anchorage point. Locate
the anchorage point behind the rear seating position (consult
the car owner’s handbook for the location of the anchorage
point). Remove the thread plug from the parcel shelf / floor/
roof and install the attachment bolt as shown in Fig 1.
For cars not fitted with a child restraint anchorage point.
For sedans only
– Drill a 9 mm diameter hole in the parcel
shelf on the centre – line of the seating position as shown
in Fig 2. Install the anchor bolt as shown in Fig 3.
For vehicles other than sedans
– In Australia, consult your
nearest child restraint fitting station or traffic authority for
vehicle inspection to find the best, correct position for the
placement of anchorage point, and for the correct
attachment bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
CHILD RESTRAINTS MUST NOT BE ATTACHED TO
UNSOUND METAL OR TO WOOD OR SYNTHETIC
STRUCTURES. WHEN DRILLING THE 9 MM HOLE DO NOT
DRILL THROUGH FUEL LINES, FUEL TANKS, ELECTRICAL
WIRING, OR RADIO SPEAKERS. WEBBING STRAPS MUST
BE PROTECTED FROM SHARP CORNERS AND EDGES.
THE ANCHOR FITTING MUST BE USED ONLY AS
DESCRIBED ABOVE. IT MUST NOT BE HOOKED ONTO
ANY OTHER OBJECT.
8
Attachment bolt
Lock Washer
Anchor Fitting
Spacers (if required)
Vehicle Trim
Upper Anchorage fittings
CAUTION: DO NOT OVER
TIGHTEN THE ATTACHMENT
BOLT. MAXIMUM
TORQUE 20 Newton Metre.
Fig 1
Front of vehicle
WARNING
WARNING
Summary of Contents for COMPLETE AIRCA 2010
Page 18: ......
