26
27
With weakest hand at
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
seat belts do not loosen,
your child restraint
should be secure.
NOTE:
Some “play”
from front to back or
about an inch from side
to side is acceptable. If it
moves more, review
“Knowing your Vehicle
Belts” and “The Locking
Clip” sections.
After checking for hot
seat and buckles, secure
child as described in
“Securing Your Child in
the Child Restraint”
section.
5
WARNING
!
Using this child restraint in any vehicle
seat where the lap belt cannot be
tightened securely and properly or where
it can be loosened by pulling on it can
result in serious injury or death.
4
Push down firmly on the
child restraint and pull up
on belt to tighten. For a
manual belt, refer to
“Knowing your Vehicle
Belt” section. Pull up on
shoulder strap to
remove any slack.
Rear Facing Use:
5-35 lbs.
(2.3-16 kg),
19-36” (48-91 cm)
3
Rear-Facing Installation with
Vehicle Belt:
Thread the vehicle lap or
lap/shoulder belt
combination through the
rear-facing belt slot.
Thread UNDER seat pad
between buckle strap and
rear slots and out
opposite side. Buckle
vehicle belt.
Do not place vehicle
belt over child’s legs.
2
Connect and tighten
harness straps prior to
installing in vehicle.
Place child restraint rear-
facing in the back seat.
With child restraint in the
reclined position, make
sure level line on side of
shell is level with ground.
Adjust child restraint if
needed.
NOTE:
Tuck the top
anchorage strap’s hook
under the child restraint.
1
NOTE:
Locking clip is
shown installed.
4358-3395E Touriva 5/15/06 9:42 AM Page 29
Page 15 of 26 Dorel Touriva / Comfort Ride / Regal Ride / Deluxe Conv (5/06)
