DOREGRILL MAG 4 GAZ, Instruction Manual

Page: 22 / 43

INSTRUCTION MANUAL ROTISSERIE MAG GAZ
SEPTEMBER 2011
22
9.5 Gas Connection
IMPORTANT: Each rotisserie is set up at the factory for a certain type of gas.
If you need to change the gas type settings, the injectors of each radiant must be
changed as well as the gas pressure regulator in the back of the rotisserie.
Conversion kit must be ordered from the factory
(See page 31: “changing injectors’’)
9.5.1 General Information
We recommend the use of a flexible hose of ¾’’ diameter with quick disconnect and a gas piping
size of at least ¾’’ as well
Make sure that the gas piping of the building and of the rotisserie are compatible
(connectors/fittings might be necessary)
Gas piping must never be installed to run under a burner
Use approved sealants at all external gas connections
Install flexible hose properly:
- Mount it between installation elbows (see #1)
- Make sure it follows a smooth, curved bend (it should form a ‘’downward ‘’U’’ loop)
(see chart 03).
- Avoid sharp bends that may restrict the gas flow to the rotisserie (see fig. 02).
In order to minimize ‘’incoming gas losses’’, hook up the rotisserie as close as possible to the inlet
supply with gas piping of a minimum diameter of ¾’’
Figure 01 Figure 02
9.5.2 Installation of the rotisserie
To connect the rotisserie to the main gas line you must use a metallic flex for natural gas and
Propane, type TUBOGAZ or similar matching norme NF D 36-123 (
voir fig. 01).
A
A
COUPE A-A
Correct
A
A
COUPE A-A
Installation incorrect
Avoid torsion of
the flex
A
DETAIL A
Gas Shut off
Pressure Limiter