Doosan NHP10-425WCU-EU-FX-T3, Operation And Maintenance Manual

Page: 28 / 88

Operating & Maintenance Manual Operating Instructions
24
Lifting Unit
Fork Tubes
— drawbar vertical stowing position.
— fork truck lifting capacity per gross weight (see general data).
Four Corner Lifting Pockets
— Use 2 spreader bars.
— Hoist/crane per machines gross weight (see general data).
Wheel Chock
— Located inside of front door.
— Secure unit with chocks before disconnecting drawbar from tow vehicle.
Before Towing
• When lifting or lowering drawbar, always grasp drawbar firmly and stand to one side.
• Ensure that the tires, wheels and running gear are in good condition and secure.
Towing
• Do not tow this unit in excess of 15 mph (24km/hr).
• Use a tow vehicle whose towing capacity is greater than the gross weight of this unit.
(see general data).
• Machine is not designed to be Highway Towable.
Setting up (All Units)
Place the unit in an open, well-ventilated area. Position as level as possible. The design of
these units permits a maximum 5 degree limit on out-of-level operation.
When the unit is to be operated out-of-level it is important to keep the engine crankcase oil
level and the compressor oil sump level at the high level mark (with the unit level). Do not
overfill either the engine crankcase or the compressor lubricating oil system.
Chock wheels.
This unit is equipped with on-board fuel tanks with a total capacity of 300 gallons which
provides 10-11 hours of full load operation.