Doosan HM 5000, Atc Troubleshooting, Page: 8 / 16

6
HM 5000/6300/8000 HM4digitATCE26
(Reference) How to correct the data
(1) Set the mode switch in the main OP to "MDI".
(2) Press the “OFS/SET” key in the right side of the main
OP monitor.
▪
The following options will be displayed in the bottom
soft key bar.
(3) Press the [SETTING] soft key.
▪
The Setting menu appears where the cursor will be
positioned to “PARAMETER WRITE” on the top.
※
If the screen is not displayed as shown in the right
picture, move to the first page of the Setting
Parameter menu (“0”

“NO.SRH”) and press
the Page Up button three times. Then, you will
see the right screen properly.
(4) Enter the number of "1" and keep pressing the INPUT
and EXEC keys.
★
The “SW0100 Parameter Enable Switch ON”
alarm will occur.