6
WARNING:
Care must be taken
not to tilt the vehicle more than 15
°
when using the serrated pad. Excessive tilting can cause the jack to
kick out suddenly and drop the load. See instruction 3 page 7.
5. Select the lifting point on the fork lift with care. It must be strong
enough to resist the lifting force without damaging the fork lift. It is
desirable to cradle the lifting point in the arm notch when
possible(See Fig.1-B).
6. Use only the serrated lifting
pad, or the notch at the end of
the lifting arm as the lifting
contact. Do not attempt to use
any other part of the
FJ4B
lack as a lifting contact point.
7. Raise a fork lift with the
FJ4B
only when:
a. The forks are in a lowered position
b. There is no load of any kind on the forks
c. There are no personnel on the jacks
8. If the fork lift truck is to be lifted, lowered and re-lifted, the following
procedure is to be followed.
a. Lift and lower in accordance with the instructions in this manual
b. Before using a second jack, make certain that the jack is
replaced in full accordance with the initial instructions in this
manual. (See Paragraph 4 of Operating Instructions)
Fig.5
