OP000470
3-21
Operation
Change Machine Control Pattern by
Select Valve (If Equipped)
NOTE:
When starting work, move work levers (joysticks)
slowly and check movement of swing and front
attachment.
The machine control pattern can easily be changed to the
ISO standard or to the standard backhoe loader hydraulic
system (BHL) by changing the position of the select valve (if
equipped). Use the following procedure to change the
position of the select valve.
The select valve is located in the rear of the cabin.
1.
Rotating spool to the ISO position or to the BHL
position. (Figure 47)
FG007624
1
5
2
6
4
3
8
7
Figure 46
WARNING!
Check surrounding area before swinging. When
operating a lever while in auto idle, do it carefully,
because the engine speed will increase rapidly.
<ISO PATTERN>
<BHL PATTERN>
FG007582
BHL
ISO
A
B
ISO
A
BHL
B
Figure 47
Summary of Contents for DX27Z
Page 2: ......
Page 6: ...K1028289E Table of Contents IV ...
Page 58: ...OP000522 Safety 1 52 ...
Page 188: ...OP000524 Inspection Maintenance and Adjustment 4 60 ...
