Input:
120 V 60 Hz
Output:
16.5 V
AC 20
VA
Single Board
Enclosure
Sold separately
P/N 2351-080
Single Board Enclosure
with Built-In Card Reader
Sold separately P/N 1815-231
DoorKing Part Number
1489-080
WIRELESS TRACKER EXPANSION BOARD RF KIT
This wireless kit provides wireless communication for a 2358-010 tracker expansion board to a wireless baseboard in a access
control system. Use wireless tracker expansion boards
ONLY
with DoorKing: 1833, 1835, 1837 and 1838 multi-door access
controller access control systems.
DO NOT
use with 1838 Access Plus model.
Plug the 1489-010 board into the wireless connector and secure boards with 4 screws to the tracker expansion board. See the HARDwired tracker
expansion board manual to connect desired options to terminals #1- #34 to manage a remote access point.
DO NOT CONNECT ANY WIRES TO
TERMINALS #10, #17, #27, #28 or #29 (Used for HARDwire communication line ONLY).
Power transformer must connect to tracker expansion
board #33 and #34
(REQUIRED)
. Antenna is
REQUIRED
, see below for antenna options.
Installation
Cabinet Mounted
Dome Antenna
Included
(Vandal-resistant) The range is
approximately 100 ft direct-line-of-sight.
Install on top of a desired cabinet in an
existing antenna mounting hole.
Other
Antenna
Options
Typical Remote Access Point Installations
May be necessary to increase the
wireless communication range
between the access control system
and the tracker expansion board(s). It
is located between the wireless antennas. It will
receive a signal sent to it by one wireless system and
repeat that signal to the next wireless system. The
range is approximately 500 ft direct-line-of-sight
with no signal interference or physical obstructions.
Wireless Repeater
Sold separately, P/N 2364-080
IMPORTANT:
Install the enclosure
so the antenna is in a location
that is
NOT
surrounded by metal
and is in free air as high as
possible above the ground.
Sin
gle Board
Enclosure Mo
unted
on a W
all
Controlling a
Vehicular Gate Operator
Sin
gle Boa
rd Encl
osure
with Built-In Card Reader
Mounted
on a Post Con
trolling
a Pedestria
n Gate/Door
34
33
32
31
30
29
28
27
26
25
24
23
22
21
14
15
16
17
18
19
20
13
12
11
10
9
8
7
6
5
4
3
2
1
1
0
BOARD ADDRESS
NC
OUTPUT
RELA
Y
NO
NC
ALARM
RELA
Y
NO
NC
AU
X
RELA
Y
NO
ENT
RESET
2358-010
RF
DATA
RF
SECURE
RF
STATUS CODE
SENT CODE
GOOD CODE
BAD
0
F
E
D
C
B A
9
8
7
6
5
4
3
2
1
ON
PR
OGRAM
RF ID
RF CH
RF
STRENGTH
RF
LOST
PO
WER
RF
SYNC
1489-010
RF RANGE
0
F
E
D
C
B A
9
8
7
6
5
4
3
2
1
0
F
E
D
C
B A
9
8
7
6
5
4
3
2
1
2358-010 Tracker
Expansion Board
1489-010
Power
Transformer
See back page.
4 Screws to secure 1489 board
to tracker expansion board.
Wireless
Connector
Cabinet Mounted
Longer Range
Fixed Antenna
Included
Externally Mounted
Longer Range
Adjustable
Antenna Kit
Sold separately,
P/N 1514-075
13 ft of cable
Range is approximately 500 ft
direct-line-of-sight. Install antenna
vertically as high as possible in free
air above Tracker Expansion Board.
Range testing is HIGHLY recommended
before FINAL installation.
Range is approximately 200 ft
direct-line-of-sight.
Install on top of a desired
cabinet.
NOT
vandal-resistant.
Important Antenna Note:
Antenna range
WILL VARY GREATLY
depending on individual setup (Antenna height above the
ground, background signal interference, physical obstructions
(trees, buildings etc.) and what antenna you choose). Adverse
weather (rain)
CAN
also affect antenna range.