17
OPERATOR PROGRAMMING
2.2.2. Automatic learning
1. Close the gate and lock the drives (if the ledge is available, adjust the leaves deceleration).
2. Enter the basic programming menu (see Basic Programming section) and select «P3» item.
3. Press the «P» button. Leaf 1 will start to open and the display will show blinking «Ln».
4. If you want to adjust the deceleration, press the «+» button while the gate leaf is moving.
5. After full closing / opening cycle two short beeps will sound and the program will automatically exit the programming
mode.
NOTE:
If safety devices are engaged then the display will show flashing «Er» (Error). Remove the cause of the error and repeat
learning.
2.3. ADVANCED PROGRAMMING
To perform advanced programming do the following:
1. Press and hold the «P» button for 10 seconds to enter the advanced programming. The left part of the display will show
«0», and the right part will show the menu item (see the Advanced Programming table).
2. Pressing the «+» or «-» buttons select the required menu item.
3. Press the «P» button to enter the menu item, the value of the adjusted parameter will start flashing on the display.
4. Pressing the «+» or «-» buttons change the value of the selected item.
5. Press the «P» button to save new value and exit to the main menu.
6. Having adjusted all the required parameters press «R» to exit the programming menu.
NOTE:
If you need to exit to the main menu without saving the parameters press «R».
Menu Item Function
Default
0.0
Pass door or single-leaf gate automation mode: Y — enabled; n
— disabled
n
0.1
Force on the 1st leaf: 1 — minimum force; 6 — maximum force
3
0.2
Force on the 2nd leaf: 1 — minimum force; 6 — maximum force
3
0.3
Maximum force at the start: Y — enabled; n — disabled
n
0.4
Pre-activation of signal lamp (5 sec): Y — enabled; n — disabled
n
0.5
Operation logics of the electric lock terminals (19–21): Y — electromagnetic; n
— electromechanical
n
0.6
Closing safety devices activation:
Y — reverse movement after the gate opening is freed of obstruction; n — immediate reverse movement
n
0.7
Automatic gate closing after activation of photocells:
Y — enabled; n — disabled
n
0.8
Gate opening/closing with buttons held pressed (faulty remote control):
Y — enabled; n — disabled
n
0.9
Prohibition of the control commands acceptance during gate opening:
Y — enabled; n — disabled
n
1.0
Separate control logics:
S-B-S button — gate opening and stopping;
PED button — gate closing and stopping;
Y — enabled; n — disabled
n
1.1
1st leaf opening time with PED button:
0 — disabled; 1 — 3 sec; 2 — 4 sec; 3 — 5 sec; 4 — 8 sec; 5 — 15 sec; 6 — 20 sec; 7 — 25 sec; 8 — 30 sec; 9 — 40 sec
0
1.2
Remote programming:
Y — enabled; n — disabled
Y
9.8
Reset to factory settings
rE
9.9
Software version
