ReMote ContRoLLeR PRoGRAMMInG
2. REMOTE CONTROLLER PROGRAMMING
2.1.
Cleaning of the receiver’s memory.
After power is on, hold down the record button for remote controllers (CODE) for 10
seconds. Indicator “A” will be constantly on, warning light will flash, then indicator “B” will be on for one second and go out
to confirm erasing of stored codes, warning light and indicator “A” will go out.
2.2.
Record of DoorHan remote controllers in the receiver.
To record remote controllers, press and hold down the record button
for remote controllers (CODE) for 3 seconds. Press twice the selected button (you later want to control the drive operation)
within 10 sec when indicator “A” is on. Indicator “B” will flash once and go out to confirm successful record of code of
remote controller in the receiver’s memory, warning light and indicator “A” will go out.
Note:
•
repeat the recording procedure for each new remote controller to set up some remote controllers.
•
in case of memory overflow in receiver, indicator “B” will flash three times (maximum number
of remote controllers in the receiver’s memory - 60 pcs.)
2.3.
Remote programming for Doorhan remote controllers.
Perform the items 1-4 within 5-second interval:
1. Press and hold down the button 2 (see figure) of programmed remote controller.
2. Without releasing the pressed button 2, press and hold down the button 1.
3. Release the buttons.
4.Press programmed button on the remote controller, the receiver enters the programming mode for remote controllers
(indicator “A” will be constantly on, warning light will flash)
Note:
•
The record of remote controller can be carried out within 10 seconds after entering the programming mode, then receiver
exits the programming mode.
5. Press the button (to later control the operation of the receiver channel) twice on new remote controller. Indicator “B” will
flash once and go out to confirm successful record of code of remote controller in the receiver’s memory, warning light and
indicator “A” will go out.
Note:
•
Programming of the remote controllers shall be carried out within the operating range of the drive receiver.
•
in case of memory overflow in receiver, indicator “B” will flash three times (maximum number of remote controllers in the
receiver’s memory - 60 pcs.)
2.4. Marking of Doorhan remote controllers buttons
1
2
4
3
2
3
4
1
1
2
2
1
6
Summary of Contents for PCB-SL
Page 7: ......
