Set Operation Mode – Stand-alone or Wiegand (Default is stand-alone)
Programming Step
Remote Control Operation
1. Enter Program Mode
2. Stand-alone Operation
3. Wiegand Reader Operation
* (Master Code) #
72 #
is factory default for stand-alone
73 #
4. Exit Program Mode
*
Set User Data Transfer Via the Remote Control
Programming Step
Remote Control Operation
1. Enter Program Mode
2. Set Transfer Data on the first SR2
For all 1000 users, this will take 3 minutes
* (Master Code) #
96 #
Within 3 minutes the green LED will shine, after 1 x bleep
the LED will turn red to confirm data transfer
3. Exit Program Mode
*
Add User Cards Via the Remote Control
Programming Step
Remote Control Operation
1. Enter Program Mode
* (Master Code) #
2.
Add Card:
Using
Auto ID number
(Allows the SR2 to assign Card to next
available User ID number)
OR
3. Add Card: Select
Specific ID number
(Allows manager to define a specific User ID
to associate the card to)
OR
4. Add Card: by
Card Number
OR
5. Add Card:
Block Enrolment
(Allows the master card to add up to 998
cards in a single step – this takes 2 minutes
)
1 (Present Card) #
Repeat Step 2 for additional user cards
1 (User ID) # (Present Card) #
The user ID is any number from 0-997
1 (Input the 8/10 digit Card number) #
1 (User ID) # (Card Quantity) # (The first card
number) #
Card or fob number MUST be consecutive
6. Exit Program Mode
*
Add PIN User – For Administrator for Remote Control
Programming Step
Remote Control Operation
1. Enter Program Mode
* (Master Code) #
2. Add PIN:
Via remote controller
1 (Enter PIN number, 4-6 digits) #
3. Exit Program Mode
*
