Dongcheng ADZC22, Operation Instructions Manual

Page: 8 / 80

8
EN
GENERAL DESCRIPTIONS
1.Locking Sleeve
2.Depth Gauge
3.Dust Cap
4.Operating Mode
Selector
5.LED Light
6.Battery Pack Button
7.Auxiliary Handle
8.Reversing Switch
Lever
9.Switch Trigger
1
8
9
2
3
4
5
6
7
CAUTION:
When installing or removing the battery pack, please
set the reversing switch lever to the center position
to lock the switch so as not to accidentally touch the
switch and cause safety problems.
The battery pack is only partially charged at delivery.
In order to ensure the maximum power of the battery ,
the battery pack must be fully charged in the charger
before the first use.
● Installing or Removing the Battery
1.Installing the Battery
As shown in the figure below. When inserting the
battery pack, please pay attention to insert the battery
pack into the casing correctly, and be sure to insert
it until you hear the sound of “click”, indicating that
the battery pack is firmly installed on the machine.
Otherwise, the battery pack may accidentally fall off
from the case, causing injury to the operator or others.
Avoid using excessive force when inserting the battery
pack or knocking it in with other objects.
1
1.Battery Pack
Only the specified battery pack can be used. Use
of battery packs of other brands carries a risk of
injury and personal injury and property damage
due to battery packs exploding.
● Removing the Battery Pack
The battery pack is under the handle of the machine,
press the battery pack button, and then pull out the
battery pack.
Caution: Do not forcefully pull out the battery pack.
1
2
1.Battery Pack
Button
2.Battery Pack
● Battery Indicator
When you press the battery pack power button,
the battery indicator on the battery pack will show
the power of the battery pack, and the power level
is indicated by the state of the 4 red LED lights
(hereinafter referred to as a red light).
1
1.Battery Indicator
The power status is shown in the following table
Status of Red LED Lights
Approx. Battery Power
Left
4 lights lit 75%-100%
3 lights lit 50%-75%
2 lights lit 25%-50%
1 light lit 10%-25%
● Continuous Use
When the battery is in continuous use until the battery
is exhausted. Cool the machine for 15 minutes before
continuing to use with a new battery pack.
● Switch Action
Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the “OFF” position when
released.
*Do not operate the machine at a low speed for too
long, or the inside machine may be overheated.
To start the tool, simply pull switch trigger. Tool
speed is increased by increasing pressure on the
switch trigger and further pressure results in an
increase in speed. Release the switch trigger to
switch off the tool.