23
Donaldson Company, Inc.
rigid caster assembly
swivel caster assembly
3/8-16 x 5-in
Gr2 hex bolt
3/8-in flat washer
3/8-in flat washer
3/8-in lock washer
3/8-16 hex nut
remove motor
panel
Caster Assembly
Caster Assembly
The caster assembly includes one rigid and one swivel
caster set.
1. Lift collector approximately 24-in with a crane or
forklift.
2. Position the swivel caster assembly under the front
filter-access end of the collector. Align bolt holes
and secure using the 3/8-16 x 5-in bolts, flat washers,
lock washers, and hex nuts supplied. See Caster
Installation.
3. Remove the lower side motor panel from the
collector.
4. Position the rigid caster assembly under the back
edge of the collector and fasten as described in Step
2.
5. Replace motor panel and lower collector.
