120 of 155
PSS5000/TEMA/803046/14
PSS 5000 – Technical Manual
9 W & M (Menu W)
4.
Press
ACCEPT
.
The message
Checking devices set OK
appears. This informs you that the
selected device now has a simulated error present.
5.
You are now able to check that the PSS 5000 has responded in the correct
way.
6.
Select
W.7 Checking Devices
again.
7.
In the
Checking Devices
window, clear the selection from the checking de-
vice error selected in Step 3.
8.
Press
ACCEPT
.
Failure to clear the checking device error results in the PSS 5000 not being
fully operational.
9.
If you want to start another checking device, repeat Steps 3. through 8.
9.7.1
Display Error (Menu W.7.1)
To activate display errors
with web service pages
The procedure used here is the same procedure as is used to check all the de-
vices, see
‘To activate checking devices with web service pages’ on page 119
.
To activate display errors
with local service panel
This procedure describes how to activate the built-in checking device that
makes sure that the Local Service Panel display checking facility is operating
correctly.
Note:
It is assumed that the Idle menu is shown in the display.
1.
Press
to move to the
LAM VERSION W.1
menu.
2.
Press , , , , ,
to
move
to
the
CHECKING DEVICES W.7
menu.
3.
Press
,
to move to the
DISPLAY ERROR
menu.
4.
Use the
and
buttons to toggle between
ON
and
OFF
.
When the Display Error value is
ON
, this simulates that there is an error on
the display. The PSS 5000 must react accordingly.
5.
Return the checking device setting to
OFF
before you leave the PSS 5000.
Failure to do this will result in the PSS 5000 not operating correctly.
