1
3
5
2
4
IMPORTANT
location of installation
security
cleaning and maintenance
Never drag the product, if necessary, ask other person’s help to remove the product from the place. Do
not place containers with high temperature on your product, at the risk of damaging plastic parts or the
upholstery.
Install your Dompel product in a level place with no grooves or splices,
preventing rocking and vibration. The location must be airy and it must not
allow straight sunlight and it must be away from sources of heat (stoves,
ovens, etc.) and flammable products. Do not install your product outdoors.
Avoid accidents. After
unpacking the product, keep
all the pack material out of
children’s reach.
Do not use metal spatulas, brushes and cleaning agents such as alcohol, acetone, kerosene, gasoline, bleach,
thinner, solvents, varsol, vinegar or other chemicals or abrasives such as sandpaper or steel brushes.
To easily clean it, use a solution of warm water with a neutral soap and then wipe dry carefully. If chemical products
reach the upholstery, clean as soon as possible, preventing the products from staining or drying the fabric. The
plastic parts can not be washed with boiling water. Chromed metal components can be cleaned with a soft, dry
flannel, and silicone-based automotive wax can be used to increase gloss and durability, in this case perform the
task following the wax manufacturer’s instructions. Perform periodic cleaning, accumulated dust affects the beauty
of the product making it difficult to clean the product.
Remove all the products from the package and follow the steps below
INSTALLATION AND ASSEMBLY
ENGLISH
Merely illustrative images.
Products may suffer changes in its components without prior warning. If any questions, contact Dompel.
Assemble the footrest (C) on the lower part of
the seat (A). Fix the 04 screws (M6 x 35-SX) (G)
pre-fixed to the seat (A) using a 10 spanner.
Manually fit the headrest (D) onto the backrest
support (B).
Manually recline the mobile backrest support
using the side handle.
Manually fit the (plastic) finishing cover (F) on
the seat back support (A). Observe the perfect
alignment of the cover holes with the support
holes.
Assemble the backrest (B) on the seat (A): partially insert the 04 backrest screws (M6 x 30-AB) pre-fi
-
xed on the part (E) using a 4mm Allen key.
IMPORTANT: Check the perfect horizontal alignment of
the backrest in relation to the seat before definitively fixing the screws (final tightening).
