![background image](http://html1.mh-extra.com/html/domo/do7047s/do7047s_instruction-booklet_2519893023.webp)
www.domo-elektro.be
DO7047S
Spraying
The spray button can be used at all times, with or without steam ironing, as long as the
water reservoir is filled up. When using the spray button for the first time press it in
repeatedly in order to activate it.
Steam shot
Through means of the steam shot you can remove tough creases.
Adjust the temperature dial to MAX (fig 3) and wait until
the indicator lamp goes out.
Press on the stem shot button. Wait a few seconds so the
steam penetrates the material before pressing again.
Please Note: Do not use the steam shot more than three
times in a row so that the best quality steam is achieved.
Repetitive use of the steam shot function will lower the
iron’s heat. For this reason, always pay attention to the temperature indicator lamp
before and after using this function.
ERROR MESSAGES AND SOLUTIONS
The iron does not warm up.
The temperature dial must be set to the correct temperature. Adjust the setting to a
higher temperature than MIN.
The iron fails to provide steam
The water reservoir is empty. Adjust the settings on the steam dial to ‘0’ and add
water. Allow the iron enough time to warm up and readjust the temperature dial to the
position marked steam ironing (•••).
The steam generating function is not working
The water reservoir must be filled to a minimum of one quarter. The temperature dial
must be set to steam ironing (•••). The iron must be in a horizontal position.
Press the steam-generating button for a second or two. Allow a short break between
each blast of steam. Make sure that you press the steam-generating button in
completely.
Spray function is not working
The water reservoir must be filled to a minimum of one quarter. For further
information please see: ‘Filling the water reservoir’.
23
Summary of Contents for DO7047S
Page 28: ...DO7047S www domo elektro be 28...