Revision: 1.0
Sapphire-BTX Setup Guide
Copyright © 2022 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 6-25
6. Basic Setup Guide
6.1 Introduction
This chapter explains how to make basic RF and video settings.
Only the settings for the BTX are explained. The receiving device must be configured accordingly to
achieve a successful radio link.
All settings are described using the web user interface, but video and RF settings can also be
configured from the LED display control via the
Config
menu, see
Chapter 4
6.2 Video Setup
Ensure the BTX has a camera video source connected to the video input BNC.
Open the web interface and go to the
Config>Video
page. Set the Video Source to Default and, using
the
Video
Helper
tool, select the video input resolution and video rate.
Click
Apply
to make the settings active.
Video lock can be verified in the
Status
page and/or by verifying the video input LED on the bottom
panel has turned green, see
Section 3.2