Domino D120i Blue IP, Product Manual

Page: 93 / 224

INSTALLATION INSTRUCTIONS
L025317 Issue 5 July 2014 2-51
Both air outlets must be kept clear. Only one silencer has to be installed to
the air outlets. Do not use silencers on both air outlets. Do not swap inlets
and outlets for compressed air.
The outer diameter of the outlet hose must be 12 mm. The length of the
outlet hose must not exceed 10 metres.
CAUTION: Follow the safety guideline of chapter 1 regarding
water cooling.
Note: It is possible to operate an air kit and a water chiller in parallel.
Both are activated via X28. For details see the water chiller
manual.
FUME EXTRACTION SYSTEM
Domino recommend installing the DPX500, DPX1000, DPX1500 or the
DPX2000 fume extraction and purifier system. These are designed to
protect personnel from hazardous dust and fumes that may be produced
by the laser marking process.
The DPX1000 is a general purpose fume extraction system that removes
particulates. The DPX2000 fume extraction system has an additional filter
and a chemical pad to remove odours and toxic gases. The DPX500,
DPX1000, DPX1500 and DPX2000 will be equipped with a connector for
the Domino D-Series Laser System.
WARNING: When printing onto PVC material, the DPX2000
Extractor should be used due to the toxic and
corrosive gases expelled during the process.
For details, see the manual included with the Fume Extraction system.