Domino Ax Series, User Documentation

Page: 90 / 167

OPERATION
4-16 EPT019297 Issue 1 November 2016
START-UP AND SHUT DOWN
Start-up
Start-up From Power Off to the Ready State
To start-up the printer from power off to the Ready state:
(1) Ensure the power connector at the rear of the printer is connected to a power source.
Note: The red status light on the power button will illuminate to indicate that the printer is
connected to a power source.
(2) Press and hold the Start/Stop button on the printer cabinet for 2 seconds.
(3) The printer will now sequence on in the follow order, this may take several minutes:
(a) The green indicator lights on the power button and start/stop button will begin flashing
to indicate that the printer is starting up.
(b) The TouchPanel screen will display the QuickStep start-up progress log.
(c) The red indicator light on the power button will turn off
(d) The status tab will display the printer status and any faults that require attention.
(e) The printer is now ready to print labels.
End of procedure.
Start-up From Power Off to the Off (Standby) State
To start-up the printer from power off to the Off (standby) state:
(1) Ensure the power connector at the rear of the printer is connected to a power source.
Note: The red status light on the power button will illuminate to indicate that the printer is
connected to a power source.
(2) Press and hold the Power button on the printer cabinet for 2 seconds.
(3) The printer will now sequence on in the follow order, this may take several minutes:
(a) The green indicator light on the power button will begin flashing to indicate that the
printer is starting up.
(b) The TouchPanel screen will display the QuickStep start-up progress log.
(c) The red indicator light on the power button will turn off
(d) The status tab will display the printer status and any faults that require attention.
(e) The printer is now ready perform non-printing functions such as creating a message.
End of procedure.
Switch Between the Ready State and Off (Standby) State
To switch the printer between the Ready state and Off (Standby) state:
(1) Press the Start/Stop button .
(2) Depending on the current printer status, the printer will enter one of the following two states:
• From the Ready state, the printer will enter the Off state.
• From the Off state, the printer will enter the Ready state.
End of procedure.