16
C.
Cleaning the Detergent Dispenser and
Grooves
Remove the drawer.
1.1 Pull out drawer.
1.2 Press lever down.
1.3 Remove drawer.
FIG. 19
1.1
1.3
1.2
2. Remove center lever, wash thoroughly,
and replace.
2.1 Lift center lever.
2.2 Wash thoroughly & replace lever.
2.3 Replace drawer.
D.
Cleaning the Inlet Filter
●
The
fi
lter
MUST
be cleaned if there is little or
no water
fl
ow when the tap is opened.
E.
Cleaning the Tap Filter
Turn off the tap.
2. Select any cycle except “Wash” or
“Drain”.
3. Press the “Start/Pause” button and keep
the cycle running for approximately 40
seconds.
4. Remove the inlet hose from the tap.
5. Use water to wash the
fi
lter if present.
6. Reconnect the inlet hose.
CARE AND CLEANING
Failure to obey the following instruc-
tions could result in death or serious injury due to
fi
re or explosion.
●
Read and understand all safety instructions.
●
Before attempting maintenance, disconnect the
power and shut the water valves off.
●
Do
NOT
use unapproved cleaning solvents that
may damage the laundering machine and gener-
ate toxic gases which can explode.
●
NEVER
spray water on the laundering machine
to clean it.
●
Any detergents containing PCMX should
NOT
be
used to clean the machine.
A.
Cleaning the Appliance Cabinet
●
Proper maintenance of the appliance can
extend its working life. The surface can be
cleaned with a diluted non-abrasive detergent
when necessary. If there is any water over
fl
ow,
use a wet cloth to wipe it off immediately. No
sharp items should be used on the cabinet.
●
Do
NOT
use any acid, diluted solvents, or
equivalent substances to clean the cabinet.
B.
Cleaning the Internal Drum
Any rust left inside the drum by metal articles
MUST
be removed immediately with chlo-
rine-free detergents.
NEVER
use steel wool
or any other abrasive cleaning materials.
●
Removing the Remaining Water in the Inlet
Hose
Burn Hazard.
This step should be
completed after the hot water inside the machine
cools down.
Turn off the tap.
2. Unscrew the inlet hose from the tap and
put its end into a large container to catch
the water.
3. Start any cycle except the Single Wash
or Drain procedure.
4. If there is any water, it will be drained out
of inlet hose for about 40 seconds.
5. Reconnect the inlet hose to the tap.
6. Remove the remaining water in the drain
pump.
FIG. 18
FIG. 20
2.1
2.2
2.3
Summary of Contents for WDCVL
Page 21: ...21 NOTES ...
