Dometic Waeco PerfectView VT100DIG, Installation And Operating Manual

Page: 30 / 200

Troubleshooting VT100DIG
EN 30
9 Troubleshooting
10 Warranty
The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see the back of the instruction manual for the
addresses) or your retailer.
For repair and guarantee processing, please include the following documents when you
send in the device:
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
Fault Cause Suggested remedy
The monitor displays
the message “
NO
SIGNAL
”.
The transmitter mod-
ule is not working. Check the voltage supply.
The monitor displays
the message
“
REVERSE FOR
IMAGE
”.
The green and the blue
cable are incorrectly
connected. Check the camera connection and
function.
The transmitter mod-
ule is not receiving a
video signal.
The monitor displays
the message “
Pair-
ing Failed
”.
The start signal (on/off
three times) is incom-
plete or missing. Repeat the system pairing until the
monitor displays “
Save data
”.
The monitor displays
the message “
wait
for TX
”.
Transmitter and
receiver modules have
lost identification. Engage reverse gear again.
Start system pairing.
The transmitter mod-
ule has no voltage sup-
ply. Check the voltage supply.
Irregular image play-
back or yellow warning
triangle on the screen. – Make sure that the antennae of the
receiver module and the transmitter
module are firmly connected.
Check the reception bars on the
monitor. If only one reception bar is
displayed, change the position of
the transmitter or receiver module.
Check if the battery charge is suffi-
cient.