CoolMatic CS-SC
Safety instructions
17
2.1
General safety
z
Caution – danger of electrocution
Check that the voltage specification on the type plate is the
same as that of the power supply.
z
Only connect the device to 24 V
DC
.
If you intend to run the device on 12 V
DC
, replace the 24 V lamp
with a 12 V lamp.
z
If the connection cable is damaged, it must be replaced to pre-
vent possible electrical hazards.
z
Disconnect the cooling device and other electric consumers
from the battery before you connect the battery to a quick charg-
ing device. Overvoltage can damage the electronics of the de-
vice.
z
Do not operate the device if it is visibly damaged.
z
This appliance may only be repaired by qualified personnel. In-
adequate repairs can cause considerable hazards.
If you device should need repairing, please contact WAECO
customer service.
z
Do not open the refrigerant circuit under any circumstances!
z
The cooler is not suitable for transporting caustic materials or
materials containing solvents.
z
Food may only be stored in its original packaging or in suitable
containers.
2.2
Operating the device safely
z
In order to work properly, the cooler must have been standing
upright for at least an hour before you switch it on.
z
Always switch off the cooler before tilting the cab. Before switch-
ing the cooler on again, let it stand for at least 15 minutes after
lowering the cab.
z
Do not place any electrical devices inside the cooler.
z
Install the device in a dry location where it is protected against
splashing water.
z
Do not install the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc).
CS-SC.book Seite 17 Freitag, 15. Oktober 2010 5:06 17
