EN
Dometic Roadmate 230
Installation
9
4
Installation
I
Make sure that all the packing materials are removed from the inside of
the door.
Check the oven for any damage, such as misaligned or bent door, dam-
aged door seals and sealing surface, broken or loose door hinges and
latches and dents inside the cavity or on the door. If there is any damage,
do not operate the oven and contact qualified service personnel.
This microwave oven must be placed on a flat, stable surface to hold its
weight and the heaviest food likely to be cooked in the oven.
Do not place the oven where heat, moisture, or high humidity are gener-
ated, or near combustible materials.
For correct operation, the oven must have sufficient airflow. Allow 20 cm
of space above the oven, 10 cm at back and 5 cm at both sides. Do not
cover or block any openings on the appliance. Do not remove feet.
Do not operate the oven without glass tray, roller support, and shaft in
their proper positions.
Make sure that the power supply cord is undamaged and does not run
under the oven or over any hot or sharp surface.
The socket must be readily accessible so that it can be easily unplugged
in an emergency.
Do not use the oven outdoors.
➤
Connect the 230 V mains cable with the 230 V output of the inverter.
➤
Turn on the inverter.
NOTE
In order to take the microwave oven in operation, you must
connect it to the power supply via the Dometic sine wave
inverter MSI924M (item no. 9102600099) (see also operating
manual of the inverter).
In addition, you can switch the microwave oven on and off by
the remote control MCR9M (item no. 9102600098) (see also
the operating manual of the remote control).
