PJS1000
Before first use
EN
15
7 Before first use
➤
Charge the jump starter before first use or after long storage until it is fully charged (see chapter “Charging the
jump starter” on page 15).
8 Operation
8.1 Switching the jump starter on
➤
Press the
button to switch the jump starter on.
✔
The LCD display switches on.
✔
The device is ready for use.
8.2 Switching the LCD display on
I
➤
When the LCD display is in power saving mode, press the
button briefly.
✔
The LCD display switches on.
8.3 Switching the jump starter off
I
1. If connected, disconnect the loads or the charging source.
2. Press and hold the
button for at least 5 seconds.
✔
The LCD display switches off.
✔
The device is switched off.
8.4 Charging the jump starter
I
The jump starter can be charged in two methods:
•
•
➤
Place the jump starter on a firm base.
➤
To charge the jump starter proceed as shown (fig.
Charging stops automatically when the jump starter is fully charged:
✔
The LCD display shows the state of charge as 100 %.
NOTE
The LCD display automatically switches to the power saving mode after 20 seconds if
no settings are made.
NOTE
• The jump starter automatically switches off after 20 seconds if no load and no
charging source are connected.
• The jump starter cannot be switched off when a load or charging source is
connected.
NOTE
When the device is discharged, a full charge takes 3 – 5 hours with either charging
method.
Dometic_PJS1000_4445103806_OPM_EMEA17_202x-xx-xx.book Page 15 Friday, October 21, 2022 8:44 PM
