EN
Connecting the awning
PW3800
10
A
There are two options for the electrical connection of the awning:
•
Remote control
or
•
Wall switch (accessory)
Observe the following installation instructions:
•
Fit the supplied main switch and fuse (15 A) to the positive line of the power
supply. The main switch is required to switch off the awning when side walls are
fitted to the awning, for example, or if the vehicle is taken out of service for an
extended period of time (otherwise the standby consumption may drain the
battery).
•
Install the receiver on the inside of the vehicle to protect it from moisture.
•
Observe the length of the cable between the awning motor and receiver when
choosing a place to install it.
•
Do
not
shorten the antenna cable.
•
Connect the ignition (D+ signal) to the orange line of the receiver. This is the only
way to ensure that the awning cannot be opened while driving.
•
When installing the supplied plug, use a suitable tool (crimping tool) to ensure
that the connection is secure and durable.
•
If you want to connect an awning light (accessory), make sure that its maximum
power consumption is 30 W. When connecting, make sure the polarity is
correct.
•
Observe the required cable cross section when connecting to the power supply:
NOTICE!
The cables and cabinets in the interior of the vehicle must not be
damaged through drilling the holes.
Cable length
Required cable cross section
2 m
1.5 mm²
4 m
1.5 mm²
6 m
2.5 mm²
8 m
2.5 mm²
PW3800-I-16s.book Seite 10 Donnerstag, 12. April 2018 3:24 15
