Dometic Oceanair SKYSCREEN, Installation And Operating Manual

Page: 15 / 160

15
EN
Skyscreen Powered Operation
8 Operation
A
I
• Only if operated by switches: When operating the blind with switches
each switch operates each blind independently.
• Only if operated with the AP Remote control: When operating the blind
with the AP Remote control each blind is independently operated via sepa-
rate channels on the remote control.
• Each blind can be stopped in any position.
• When operating the blind with an automation system, the operation is
dependent on the programming of the control interface.
• The blind automatically stops
–
When the blind is fully deployed
– When the blind is fully stowed
– If the blind hits an obstruction (including the other moving rail)
9 Cleaning and maintenance
A
NOTICE! Damage hazard while driving
Only for boats and yachts:
If the blind is fitted beneath an open sunroof,
then the blind should be stowed when driving at more than 10 knots or with a
sea state of more than moderate, because this can damage the blind. Parts that
come loose may injure people in the vicinity.
NOTE
• When operating the blind using switches or an automation
system:
If the movement direction is reversed too quickly, the motor might
not detect the polarity change and will just stop. To prevent this, the power
must be off for at least 0.5 seconds before the movement direction is
reversed.
• When the motor is stopped the power consumption falls to 8.5 mA. After
approximately 4 minutes the motor automatically switches off.
NOTICE! Damage hazard
• Do not grease, oil or lubricate the blind. Lubricants will damage the fabric.
• Be careful not to crease the fabric when using the brush attachment of a
vacuum cleaner.
• Rubbing can damage fabrics. Do not scrub.
• Spot-cleaning may result in cleaner areas than the surrounding.
• Do not soak the blinds.
• The manufacturer recommends testing any cleaning agents on a hidden
area of the blind first.