32
There should be a distance of at least 10 cm between the back of the unit and any other
object (wall).
Avoid placing unit in direct sunlight and next to other sources of heat.
Ventilating ducts on the upper, lower and rear end of the mobilCooler should be kept clear
of all obstructions to ensure good air circulation.
This will result in a good, energy-saving cooling system.
5. Cleaning
Before initial use and after defrosting or before prolonged periods of disuse, clean the unit
containers and lid with lukewarm water and, if necessary, washing-up liquid. Warning: do
not inadvertently press or force the opened lid past its stop-point (this could cause the
hinges to break). Never use scouring or corrosive agents to clean the unit. Wipe cleaned
surfaces dry with a soft cloth.
6. A/C operation
Do not use any additional form of energy (batteries/gas).
Check that the supply voltage and line voltage data correspond to the type-plate on the
back of the unit.
(The following instructions refer in the main to coolers manufactured in the United
Kingdom). The mains lead of your mobilCooler is fitted with a non-rewirable, moulded-on,
13-amp plug containing a 3-amp fuse. It is a regular earthed plug for connection to a
regular earthed socket.
Due to the difference in the plugs used, an adapter will be necessary for other countries.
If the fuse requires replacing at any time, the fuse cover/carrier should be removed using
a small screwdriver to lever it out. The old fuse should be replaced by a 3-amp, ASTA-
approved, BS 1362 fuse and the fuse cover/carrier must be refitted before the plug is used
again.
If the fuse cover/carrier is lost, a replacement can be obtained from the Electrolux Service
shops and offices. The fuse cover/carrier must be of the same colour as that of the
coloured insert in the base of the plug. Under no circumstances must the plug be used
without a correct fuse cover/carrier fitted.
If the plug supplied on the mains lead is not suitable for the socket in your home, it should
be cut off and disposed of safely, or destroyed, to avoid any possible shock hazard
resulting from the plug being inserted into a 13-amp socket elsewhere in the house. A
suitable replacement plug should then be fitted as given below.
General guide to fitting any plug
Ensure the lengths of wire inside the plug are prepared correctly. Connections should be
firmly made after all conductor strands are entered into the terminal posts. When
preparing the cable ends, take care not to damage the outer sheath or the insulation
surrounding the inner conductors. Tighten all screws. Replace the top cover of the plug
and secure.
Other versions
Your mobilCooler has a 3-wire mains lead which is intended for connection to a 3-pin plug
and a properly earthed socket outlet.
GB
All manuals and user guides at all-guides.com
