Dometic miniBar RH 430LD, Installation And Operating Manual

Page: 19 / 192

EN
RH4xxLD, RH4xxLG Troubleshooting
19
9 Troubleshooting
Problem Possible cause Suggested remedy
Device is not cooling
(the cooling unit at
the back of the
device is cold). The device plug is not
plugged in. Plug the device plug in.
No voltage present in the
AC voltage socket. Check fuse or try using another plug
socket.
The device is in its defrost-
ing phase. Check again if the device is cooling
after 2 hours as the defrosting phase
lasts 2 hours.
The electronics or the sen-
sor is defective. This can only be repaired by an author-
ised customer services unit.
The heating element is
defective.
This can only be repaired by an
authorised repair centre.
Device is not cooling
(the cooling unit at
the back of the
device is warm). The device is not level. Level the device using a spirit level.
The device was only
switched on a short while
ago. Let the device run for 5 to 6 hours.
The cooling unit is
defective.
This can only be repaired by an
authorised repair centre.
The devices cooling
performance is poor. The cooling unit is not
sufficiently ventilated.
Check that the ventilation grids are not
covered.
Check that device has been installed
in accordance with fig.
2
, page 3.
The device is exposed to
heat or direct sunlight. Relocate the device.
The device door does not
close tightly. Check if the door is installed correctly.
An authorised repair centre can install
a new door seal if necessary..
The device was stocked a
short while ago. Check the temperature after 5 to
6 hours.
Frost is forming inside
the device. The device door does not
close tightly. Check if the door is installed correctly.
An authorised repair centre can install
a new door seal if necessary.