leave some space between the products in the cabinet to ensure efficient and even cooling. If the
shelves are packed too tightly there may be unacceptable temperature variations.
8. Defrosting, cleaning and maintenance
Frost will gradually form on the cooling surfaces and it must not be allowed to become too thick since
it restrict the cooling.
This frost-formation is kept back by the FUZZY LOGIC system built into the appliance by switching off
the unit "0", disconnect the refrigerator from the electricity supply and leave the cabinet door open.
After defrosting the cabinet interior should be wiped out with a clean, damp cloth.
Figure 6.
9. Changing the lightbulb
(If available)
If the lightbulb needs changing, pull out the plug
and proceed as follows:
Press the metal reflector to one side and draw the
lamp covering backwards. Replace the bulb and
push the covering back into place.
A new 10-watt bulb can be obtained at any service
shop.
10. Reversing the door hang,
(Fig. 7)
Lay the appliance on its back. Remove the 8
screws (1). Remove the door, together with the two
hinges (2), from the housing.
Remove the two cover caps (3) from the housing
and place them in the open hinge holes in the
housing. Place the bottom righthand hinge in the
top left of the door and the top righthand hinge in
the bottom left of the door and hang the door on its
hinges in the open cover cap holes in the housing.
Secure the hinges and cover caps with the 8
screws.
Check that the door closes easily and is sealed properly.
