10
EN
Installation and Setup
6 Installation and Setup
NOTICE:
Do
not
use a screw gun and do
not
over-
tighten the screws when mounting the display because
either method may damage the display.
NOTICE:
The system’s air sensor is located in the control
display panel; therefore, you
must
locate the display
on an interior wall at eye level. Do
not
locate in direct
sunlight or inside a cabinet. If these conditions cannot
be met, you
must
purchase the optional remote air
sensor and install it in the return-air stream.
NOTICE:
Do
not
staple sensor cables when mounting.
This section describes how to install and set up the Smart
Touch Cabin Control.
6 .1 Choosing the Location
This section describes the location requirements.
q
7
Front Panel Temperature Sensor
q
Temperature Sensor Location
1. Before mounting the control panel, consider the
location. The display panel’s built-in air sensor
provides excellent room-air temperature sensing
when properly located and installed. For the sensor
location on the display panel, see Figure 7.
I
If you cannot mount the display in a suitable
location, install the optional remote air sensor.
2. Ensure the following requirements are met when
mounting the display panel.
– Install the display on an inside wall, slightly higher
than mid-height of the cabin.
– Select a location with freely circulating air where
the temperature sensor can best sense average
temperature.
– Select a location within 15 ft (4.5 m) of the air
conditioning unit to accommodate the length of
the display cable (custom lengths are available).
– Avoid installing the display in direct sunlight, near
any heat-producing appliances, or in a bulkhead
where temperatures radiating from behind the
panel may affect performance.
– Avoid installing the display in the supply air
stream, above or below a supply air or return-air
grille, behind a door, in a corner, under a stairwell,
or any place where there is no freely circulating air.
6 .2 Installing the Display Panel
This section describes how to mount the display panel.
w
q
8
Top View Mounting Dimensions
q
1 in. (25 mm)
w
0.4 in. (10 mm)
Summary of Contents for MCS-CTRL
Page 42: ...42 EN Smart Touch Cabin Control...
