8
EN
Installation
MasterFlush 7600 Series Toilet
2. Disconnect and drain the water supply line.
3. Remove the toilet hold-down bolts and screws.
4. Remove the toilet from the floor.
5. Remove and dispose of the old floor flange seal, the
hold-down bolts, and any removal debris.
6 .3 Installing the Toilet
This section describes the two toilet installation options.
6 .3 .1 Floor Flange Installation
I
To install the toilet farther from the holding tank,
skip to “Remote Installation” on page 9.
NOTICE:
When lowering the toilet onto the floor flange,
the toilet
must
align so that the outlet at the base fits
inside the floor flange outlet hole.
NOTICE:
The floor flange
must
be secured to the floor
with a minimum of four screws (eight is recommended).
Complete these steps to perform a floor flange toilet
installation:
1. Verify the top surface of the floor flange is clean and
free of any debris or sealant.
q
w
e
6
Installing the T-Bolts
q
T-Bolts
e
Floor Flange
w
Slots
2. Verify the new flange’s toilet mounting holes are at
the correct location. See Figure 4 & Figure 6.
3. Secure the floor flange to the floor.
4. Insert the two T-bolts into the floor flange slots.
q
e
r
t
w
y
7
Installing the Floor Flange
q
Floor Flange Seal
r
Floor Flange
w
Bolt Covers
t
Water Supply Connector
e
Floor Mounting
Nuts and
Washers
y
Black Rubber Elbow
5. Verify the floor flange seal is installed onto the base of
the toilet.
6. Carefully set the toilet over the floor flange.
7. Align the holes in the toilet base with the T-bolts as
the toilet is lowered onto the floor flange.
I
Do not rest the entire toilet base completely
on the floor at this time. The floor seal must be
compressed. Refer to the following steps.
