EN
Troubleshooting
MaCave
29
The light does not work.
Appliance is not connected to a
power supply
Connect the appliance
Circuit breaker or fuse has blown
Switch on circuit breaker or
replace fuse
The light was switched off on the
control panel.
Switch on the light
The appliance vibrates
The appliance is not properly
level
Level the appliance with the
adjustable feet
The appliance seems to
make a lot of noise
The noise is probably caused by the refrigerant, which is normal.
At the end of each cycle, you will hear noises made by the flow of
refrigerant.
If temperature fluctuations occur, the contraction and expansion
of the inner walls may cause popping and cracking noises.
The appliance is not properly
level
Level the appliance with the
adjustable feet
The door does not close
properly
The appliance is not properly
level
Level the appliance with the
adjustable feet
The door hinge was changed
incorrectly
Check the door hinge and
reassemble correctly
The door seal is dirty
Clean the door seal
The shelves are not fitted cor-
rectly
Check the shelves and refit
correctly
LED indicates
E1, E2
or
E7
.
The temperature sensor for the
fan inside the appliance shows
an error
This can only be repaired by
an authorised repair centre.
Problem
Possible cause
Remedy
Summary of Contents for MaCave S118G
