EN
a
Operating the roof air conditioner
FreshJet3000
18
7.8
Adjusting the air nozzles
The air supply within the vehicle can be regulated by setting the air nozzles.
➤
Turn the slats (fig.
1, page 4) in the air nozzles independently in the required
directions. The air flow can be adjusted along the ceiling or towards the floor.
7.9
Setting the timer
The timer function allows you to set a specific time period for air conditioning. You
can specify the number of hours until the air conditioner will be switched on and the
number of hours until the air conditioner will be switched to stand-by (up to
24 hours).
I
➤
Before programming the timer, select the air conditioning mode and all required
values (e.g. temperature).
Setting the switch-on and the switch-off time
I
➤
Press the
button once.
✓
The
ON
symbol flashes on the display of the remote control.
➤
Use the
+
or
–
button to set the number of hours until the air conditioner will be
switched ON.
➤
Press the
button again to confirm the value.
✓
The switch-on time is set on the roof air conditioner.
The roof air conditioner is switched on with the selected air conditioning mode
at the specified time.
✓
The
OFF
symbol flashes on the display of the remote control.
If no OFF time is needed press the
button again without changing the hour value.
➤
Use the
+
or
–
button to set the number of hours until the air conditioner will be
switched to stand-by.
➤
Press the
button again to confirm the value.
NOTE
The remote control returns to its initial mode if no button is pressed on
the remote control for 15 seconds while programming the timer.
NOTE
The ON timer can only be set when the unit is turned OFF.
FreshJet3000-OPM.book Seite 18 Donnerstag, 27. Februar 2020 4:17 16
