Dometic FAN-TASTIC VENT, Installation And Operating Manual

Page: 17 / 240

EN
FanTastic Vent Installing the device
17
6.1 Pressing out the hole
See fig.
2
, page 4
6.2 Using the reinforcing rails
Proceed as follows (fig.
3
, page 4):
➤
Before installation, check whether the roof opening needs reinforcing.
➤
Remove the foam according to the width of the reinforcing rails (not in scope of
delivery) (
A ).
➤
Fit the reinforcing rails ( B ).
7 Installing the device
!
➤
Run the 12 V connection through the roof.
➤
Trim the inner frame depending on the thickness of the roof (fig.
4
, page 4).
➤
Check that the roof light has sufficient space around it (approx.1 to 2 mm) in the
roof opening (fig.
5
, page 5).
➤
Clean the roof opening in the mounting area (fig.
6
, page 5).
➤
Place a gasket or sealant around the roof opening (fig.
7
, page 5).
➤
Check the direction of travel when installing (fig.
8
, page 6).
➤
Make sure the cover hood hinge is towards the direction of travel.
➤
Place the roof light into the middle of the roof opening (fig.
8
, page 6).
➤
Connect the cable to the 12 V connection (fig.
9
, page 7).
➤
Check the fan works properly.
➤
Screw the roof light to the roof tightly. Use all the screw holes provided to do this
(fig.
0
, page 7).
➤
Seal the roof light (fig.
a
, page 8).
➤
Seal the screw heads (fig.
a
, page 8).
WARNING! Beware of injury!
Disconnect the vehicle power supply before you begin and make sure it
cannot be restarted.
FanTastic-Vent-IO-16s.book Seite 17 Freitag, 5. Mai 2017 11:41 11