Dometic CT 4110, Installation Manual

Page: 29 / 248

EN
CT(E), CTLP, CT(E)S, CTW Electrical connection
29
7 Electrical connection
!
A
I
7.1 Models CT(E)4xxx, CTLP4xxx, CT(E)S4xxx with
external water pump
A
1. Connect the cassette toilet via the main terminal block of the vehicle to its own
power supply (fig.
n
, page 16).
2. Connect the external water pump (fig.
o
, page 17).
WARNING!
Have the electrical connection carried out by an electrician.
NOTICE!
• Do not connect the cassette toilet to the voltage supply directly in
parallel with other power-consuming devices.
• Do not connect the control of the cassette toilet to a pressurized
water pump.
• The rated capacity of an external water pump should not exceed
60 W.
NOTE
• The external water pump is not included in the scope of delivery.
• A pre-fuse is not necessary, because the cassette toilet is internally
fused.
NOTICE!
• The rated capacity of an external water pump should not exceed
60 W.
• The 12 V connection cable must have a cross-section of at least
1.5 mm
²
.
• A 7.5 A automotive fuse is integrated in the toilet control.