EN
CFX95DZW
Operation
17
6.5
Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤
Connect the cooler, see chapter “Connecting the cooler” on page 15.
A
➤
Press the “ON/OFF” button (fig.
3
1, page 3) for between one and two sec-
onds.
✓
The LED “
P
” lights up (fig.
3
2, page 3).
✓
The displays (fig.
3
6 and 7, page 3) switch on and show the current
temperatures.
✓
Depending on the compartment set temperatures, the cooler starts cooling
either one or both compartments.
✓
The LEDs (fig.
3
5 and 8, page 3) light up when the respective compartment is
cooling.
I
Latching the cooler lid
➤
Close the lids.
➤
Press the latches (fig.
2
1, page 3) down, until they latch in place audibly.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTE
Place the cooler as shown (fig.
1
, page 3). If you operate the box in a
different orientation it can be damaged.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
NOTE
When operating with the battery, the display switches off automatically
if the battery voltage is low. The LED “
P
” flashes orange.
