Dometic CoolFreeze CF-35, Operating Manual

Page: 15 / 284

EN
CF35, CF40, CF50 Operation
15
I
6.5 Using the cooler
A
➤
Place the cooler on a firm foundation.
Make sure that the ventilation slots are not covered and that the heated air can
dissipate.
I
➤
Close the cooler, see chapter “Connecting the cooler” on page 13.
I
A
➤
Press the “ON/OFF” button (fig.
3
1, page 3) for between one and two
seconds.
✓
The “POWER” LED lights up.
✓
The display (fig.
3
5, page 3) switches on and shows the current cooling
temperature.
NOTE
When the cooler is supplied by the starter battery, select the battery
monitor mode “HIGH”. If the cooler is connected to a supply battery,
the battery monitor mode “LOW” will suffice.
If you wish to operate the cooler from the AC mains, set the battery
monitor to the “LOW” position.
NOTICE! Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the heat that
generated during operation can dissipate. Ensure that the ventilation
slots are not covered. Make sure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTE
Place the cooler as shown (fig.
1
, page 3).If you operate the box in a
different position it can be damaged.
NOTE
If you wish to operate the cooler from the AC mains, set the battery
monitor to the “LOW” position.
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
CF35-CF50-O-16s.book Seite 15 Montag, 9. Juli 2018 9:09 21