Dometic COOLAIR RT780, Installation Manual

Page: 15 / 308

11
EN
CoolAir RT780, SP950T Installation
SP950
I
7.2 Removing the sunroof
Proceed as follows (fig.
6
):
➤
Remove all screws and fixtures of the existing sunroof.
➤
Take out the sunroof.
➤
Remove the sealant around the opening, so that the surface is clean and free
of grease.
I
7.3 Preparing the unit fastening
➤
If necessary:
Enlarge the existing
∅
6.5 mm drill holes for fastening the sunroof to a
diameter of 8.5 mm (fig.
7
).
No. in
fig.
5
Designation
1 Condensate pump
2 Evaporator fan
3 Operating circuit board
4 Temperature sensor
5 Level sensor
6 Control unit
7 25 A fuse
8 4 A fuse vaporiser fan
9 4 A fuse condenser fan
10 Condenser fan
11 Compressor
12 Klickson (compressor)
bl br gl gr ro sw w
Blue Brown Yellow Green Red Black White
NOTE
After installing the unit, the specified parameters of the unit software must be
checked (chapter “Configuration of unit software” on page 15).
NOTE
Dispose of all waste material, glue, silicone and seals separately. Observe the
local disposal guidelines.
576378QL,VERRN6HLWH'RQQHUVWDJ'H]HPEHU