EN
Cleaning and maintenance
CDF236
22
I
6.13
Replacing the light PCB
A
7
Cleaning and maintenance
A
➤
Occasionally clean the cooling device interior and exterior with a damp cloth.
➤
Make sure that the air inlet and outlet vents on the device are free of any dust and
dirt, so that heat can be released and the device is not damaged.
8
Troubleshooting
NOTE – Internal DC fuse
There is an additional DC fuse inside the device (Automotive standard
blade fuse, 10 A). This fuse can only be replaced by an authorized repair
center.
NOTICE! Damage hazard
The lamp can only be replaced by the manufacturer, a service agent or
similarly qualified person to avoid hazard.
NOTICE! Damage hazard
•
Never clean the cooling device under running water or in dish water.
•
Do not use abrasive cleaning agents or hard objects during cleaning
as these can damage the cooling device.
Fault
Possible cause
Suggested remedy
When operating from
the DC power socket:
Device does not
function, LED does not
glow.
No voltage is flowing
from the DC power
socket in your vehicle.
The ignition must be switched on in
most vehicles to supply current to the
DC power socket.
The device does not
cool (plug is inserted,
POWER LED is lit).
Defective compressor.
This can only be repaired by an
authorized repair center.
DometicCDF2-36_OPM_4445102509_EMEA17_202x-xx-xx.book Page 22 Thursday, September 15, 2022 2:57 PM
