10
D. Heating Operation (With Optional
Electric Heater Installed)
This electric heater will
NOT
replace a fur-
nace for heating your boat in cold weather.
The intent is to remove the chill on cool days
or mornings using a 1.6 kW heater.
1. Turn the selector switch to “HEAT”. There are
three positions: HIGH FAN, MED FAN or LOW
FAN to select from, depending upon personal
choice. See (FIG. 18).
2. Use low fan speed with the electric heat strips
(use of higher speeds will make the outlet air
feel cool, but all heating speeds deliver the same
watts of electric heat to the boat).
3. The heat strip will come on and begin heating.
4. The element will “cycle off” when the thermostat
is satisfied. The fan will continue to run help
-
ing keep the temperature throughout the boat
uniform.
E. Fan Operation
1. This will circulate the air in your boat without
cooling or heating. There are three positions:
HIGH FAN, MED. FAN or LOW FAN to select
from, depending upon personal choice.
A. Controls
1. The Selector Switch has 10 positions including
“OFF”. This controls fan speed, optional heating
mode, and cooling modes. See (FIG. 18).
FIG. 18
2. The thermostat controls the temperature range
at the filter between approximately 18 °C and
32 °C.
B. “OFF” Position
1. This is to turn unit off.
C. Cooling Operation
1. Set the thermostat at the desired temperature
level.
2.
Select the fan speed that best satisfies your
needs:
a. HIGH COOL: Selected when maximum cool-
ing and dehumidification required.
b. MED. COOL: Selected when normal or aver-
age cooling required.
c. LOW COOL: Selected when room is at de-
sired comfort level and needs to be main-
tained. Normally this speed used for night time
operation.
The blower runs continuously to circu-
late air and maintain an even temper-
ature. The compressor will come on
as cooling is required to maintain the
selected temperature level.
OPERATING INSTRUCTIONS