Dometic 9600000109, Installation And Operating Manual

Page: 15 / 196

VT100WiFi Troubleshooting
EN
15
When connected to the reversing light
➤
Switch on the vehicle's ignition.
➤
Engage the reverse gear of the vehicle.
✓
6 – 8 seconds after engaging in reverse gear, the transmitter is ready for operation.
➤
Connect your receiving device to the wireless network of the transmitter. Use the address and
the password to do this, which can be found on the transmitter housing.
➤
Start the VT100WiFi app on your receiving device.
✓
The receiving device displays the camera image.
✓
After three seconds without further action, the receiving device switches to full-screen mode.
✓
Double-click on the screen to open the control bar.
9 Troubleshooting
Problem Cause Suggested remedy
The receiving device
cannot find the
transmitter's wireless
network. The transmitter does not
work. Check the power supply.
The transmitter's
operating display does
not light up.
The app on the receiving
device has a black
screen. The transmitter does not
work. Check whether the app responds:
open the control bar by double-
clicking on the screen.
Check the transmitter connection and
function.
The app on the receiving
device has a blue screen
but the receiving device
is connected to the
wireless network of the
transmitter. The green cable is not
connected correctly. Check the camera connection and
function.
The transmitter is not
receiving a video signal.
The receiving device cuts
off during image play-
back and displays a
yellow warning triangle. The connection between
transmitter and receiving
device is too weak. Make sure that the antenna of the
transmitter is connected properly.
Check if the vehicle battery is charged
sufficiently.
VT100WiFi-IO-16s.book Seite 15 Donnerstag, 14. Juli 2016 3:57 15