EN
Installing the Heki2
Heki2
8
See fig.
8
➤
Check the direction of travel when installing.
You can fit the roof light sideways (hinge-side at front in direction of travel) or
lengthways (hinge-side on left or right in direction of travel).
➤
Place the outer frame in the middle of the roof opening.
➤
Press the outer frame in the roof slightly so that the packing compound spreads
out.
See fig.
9
➤
Place the 16 mounting supports on the inside of the vehicle all the way into the
recess of the outer frame.
➤
Attach the 16 mounting supports using the fastening screws
∅
4
.
To do this use the large holes in the mounting supports.
➤
Tighten the screws 10 minutes after installation.
See fig.
0
➤
Place the inner frame on the outer frame and fasten it with the fastening screws
∅
2.5 x 12 mm into the 16 mounting supports.
To do this use the small holes in the mounting supports.
Only fasten the screws slightly by hand.
➤
Check that the roller blinds can move freely.
If they do not, then loosen the screws slightly.
See fig.
a
➤
Clip on the ventilation grille (
1
).
It needs to click in.
➤
Remove the protective film from both sides of the acrylic glass.
I
➤
After installing, check the roof light works properly.
➤
If necessary, enter the new vehicle height and weight in the vehicle documents.
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
Heki2-IO-16s.book Seite 8 Montag, 28. November 2016 8:56 20
“More information https://www.caravansplus.com.au"
